| Step 1 |
Pick the component you would like to glue a bail onto the back of. We chose a heart shaped molded resin piece.
| Step 2 |
Place a small drop of an adhesive onto the top center of the back of the molded resin piece. We chose to use E6000.
| Step 3 |
Place the glue back bail of your choice over the adhesive at the top center of the molded resin piece.
| Step 4 |
Firmly press the bail onto the back of the piece.
| Step 5 |
Allow the adhesive to dry. E6000 will be fully dry in a minimum of 24 hours. The drying time of your piece may vary depending on the adhesive you decide to use.
| Step 6 |
Congratulations! You have now created a pendant using a glue on bail.