Swarovski cosmic crystals are paired up with silver colored filigrees to make this statement bracelet project.
1) Run a bead of glue along the back of one of the Cosmic Rings and then fit the Ring into one of the Ring Settings. Repeat this step with the remaining Crystals and Settings and allow to dry for at least 1 hr before assembling the bracelet.
2) Open all of the Jump Rings and with the first, attach two of the Filigree Connectors so that the backs face one another. Before closing, also attach the Lobster clasp.
3) On the other side of the two "sandwiched" Filigrees, use another open Jump Ring to attach the Filigree Connectors to one of the Crystal Settings. Go to the other side of the Crystal Setting, and use another open Jump Ring to attach this to two more "sandwiched" Filigree Connectors. Continue to connect both the Crystal Settings and Filigrees until all are connected. Make sure that all of the Jump Rings are closed securely.
4) Take the final open Jump Ring and use this to attach the Chain Extender to the end of the bracelet. Leave the bracelet alone so that the glue holding the Crystals can cure for about a day. After that, you're done and the bracelet is ready to wear! Quantity of Items Needed
1 Lobster Clasp
12x6mm Silver Plated
8 Connector - Filigree 17mm Silver Plated
1 Chain Curb
4.5mm with Drop Silver Colored
3 Cosmic Ring Setting 2-Loop 14mm Pewter Antique Silver Plated
3 Swarovski Cosmic Ring 4139 14mm Crystal Vitrail Light
8 Jump Ring - Open 4mm Silver Plated