HOME NEW Pearl Education Beading Q & A Tools Jewelry Tech Video Jewelry Glossary

DIY Sequin Maxi Wrap Skirt

This sequin maxi wrap skirt is so beautiful and brightly designed for the this season. Have a look at this!
DIY Sequin Maxi Skirt
You need:
– Sequin fabric measuring 1.5 x your waist in length (and 62in in width). It’s best to pick a sequin in a matte colour like bronze or copper for a subtle and less brassy style.
– Instant bond sewing tape 
– Needle and thread
DIY Sequin Maxi Skirt 8
DIY Sequin Maxi Skirt 9
How to:
Below is the basic pattern for your skirt. It’s super simple and there are only a few basic steps – I took the sequin fabric, made sure it was the right length and width for my body, finished the edges with instant bonding tape, then added velvet ribbon to tie in a bow at the back and finally snap buttons so it all stayed in place nicely.
DIY sequin maxi skirt2

2. Once you’ve cut the piece of fabric to size (everyone’s body is different so play around and trim where necessary), run the instant tape along the hems and side edges of the fabric, about 5cm/2.5in in from the edge.
DIY Sequin Maxi Skirt 10
3. Remove the plastic backing the whole way along.
DIY Sequin Maxi Skirt 11
4. Fold the edge over and press firmly onto the tape. For best results, fold over twice so no raw edge is showing.
DIY Sequin Maxi Skirt 12
5. Do this all the way around the edges of the fabric, folding the sequins if you are dealing with the cut edge. The fabric should end up looking a little like the image below.

DIY Sequin Maxi Skirt 14

6. Now you are going to attach the velvet ties which will make sure the skirt is nice and tight around the waistband. Cut the velvet in half (run a lighter/match along the cut edge to stop fraying).  Wrap the skirt around you and at the back pin the velvet ties in place, tying in a bow to check how it sits. Once you are sure they are sitting in the right place, use your needle and thread to sew the velvet ribbon on.
DIY sequin maxi skirt
7. Each side of the velvet ties should look like this. I sewed a few lines to reinforce the two pieces.

 

DIY Sequin Maxi Skirt 16
8.  Sew the snap buttons on using the needle and thread. The pattern at the top shows where I put the buttons, but it is indicative and the easiest way to check where the buttons should go is by putting the skirt on, tying the velvet ribbon and using pins to mark where the buttons should attach on both top ends of the fabric. Make sure to sew the buttons the right way up so they press together properly.
a pair and a spare 5
9. The back of your skirt waistband should look like this once it is done, with one side sitting over the top and one on the underside, both button down nicely.

 

a pair and a spare 4

And there you go! Such a simple piece for party celebrations, I love pairing mine with a silk midriff top or slouchy singlet and simple black flats.

DIY Sequin Maxi Skirt 5
I hope you all have amazing holiday celebrations that sparkle as much as the sequins you’re wearing!