HOME NEW Pearl Education Beading Q & A Tools Jewelry Tech Video Jewelry Glossary

DIY Friendship Bracelet Hand Chain

I love a good arm party, and goodness knows I have a sizable collection of golden rings, so anything that combines the two is more than okay in my book. I’ve been eyeing this BaubleBar hand chain and this hand lariat from Nordstrom for awhile, so I decided to try my hand at combining the hand chain silhouette with a colorful friendship bracelet for a sparkly, summery statement piece.


For this project, you’ll need the following:
• embroidery thread
• a small length of delicate chain
• a small length of curb chain
rhinestone cup chain
jump rings
lobster claw clasp
• plain gold ring
• square pronged connector
needle-nose pliers
• sewing needle

1. Start by making your friendship bracelet. I decided on a chevron pattern using five different colors, which determined the width of the bracelet. Here’s a good tutorial if you didn’t go to camp and are therefore not familiar with the art of friendship bracelet-making. Don’t forget to leave extra string on the ends so we can finish them neatly.

2. Now that we have the base bracelet made, all we have to do is add on to it. I started by cutting a length of curb chain that was exactly as long as the friendship bracelet. Then, I simply tacked it onto one side of the bracelet using a whip stitch. You can see these stitches in the photos (using turquoise thread).

3. Next we will add our rhinestone chain to the top of the bracelet. For this step, I simply tacked on the chain using little stitches across the chain in between the rhinestones. The nice thing about sewing onto a friendship bracelet is that the pattern hides stitches pretty well, so you don’t have to be too careful. If you look really hard, you can see these red stitches in the photos.

4. Once we have our bracelet assembled, it’s time to finish the ends. Make sure both sides are tied off nicely and trim any excess thread. Then, dab a little bit of super glue into your square connector, place the knotted end into the finding and hold for about 30 seconds until the glue has somewhat set. To finish, simply use your pliers to fold the prongs down, tightly secure the knots.

5. After the glue has dried completely, use a jump ring to add the clasp of your choosing to one side of the bracelet and a jump ring or extender to the other.

6. Now it’s time to connect the pieces. First, measure the length between your wrist and where the ring will sit on your finger and cut a chain to this length. For reference, mine was about four inches.

7. Add a small jump ring to either side of the chain, and attach one end to the curb chain on the bracelet and the other end to the ring.

8. Style alone for a simple statement, or layer up with a stack of colorful bangles!