HOME NEW Pearl Education Beading Q & A Tools Jewelry Tech Video Jewelry Glossary

DIY Evil Eye Bracelet

Learn the specific method of how to make this nice evil eye bracelet jewelry from Beads.How. It's really nice and perfect with the evil eye and unique designs. Hurry up getting started from this project of this strand nice evil eye and hamsa bracelet jewelry!

DIY Sliding Knot Bracelet


You’ll need:

  • evil eye or hamsa charm
  • 12 inches of chinese knotting cord
  • scissors
  • lighter

Thread 4 inches of cord through one side of the charm. Fold 2 inches of cord back on itself and then again to create a zig zag.


Fold an inch of the tip down over the parallel cords. Coil the cord three times towards the loop.


Thread the tip through the opening of the left loop.


Push the coil to the right and pull the tip until the knot is tight. Test the adjustable knot by sliding it towards the base of the charm. The excess cord will be trimmed later.


Thread the other end of the cord through the opposite side of the charm and create the same zig zag.


Coil the tip around all the cords three times and thread the tip through the loop.

Push the coil to the right and pull the tip until the knot is tight. Trim both ends, leaving approximately 2-3mm.

Melt the ends with a lighter.

Your bracelet is finished

And you’re now protected against the evil eye!